American Audio DIGI-PRO Guia do Utilizador descarregar pdf (Página 198)

ProControl Guide192

Reset and UNDO

Changes to UTILITY parameters are applied

as you make them. In other words, you

cannot ESCAPE out of UTILITY mode with-

out saving any changes you have made —

they are saved as soon as a new parameter

is selected. To reset a UTILITY parameter

you must manually access and reset the op-

tion.

Display of UTILITY status

UTILITY mode choices and settings are dis-

played in the DSP EDIT/ASSIGN and Chan-

nel scribble strip displays.

When editing parameter choices on the

UTILITY pages, menu choices which are

currently enabled, or active, are indicated

by a lit switch LED. Other available choices

are shown with a ﬂashing ASSIGN/ENABLE

switch LED.

To select/edit a UTILITY parameter:

■ Press the ﬂashing ASSIGN/ENABLE

switch in the DSP EDIT/ASSIGN section as-

sociated with the parameter you want to

edit. If an ASSIGN/ENABLE switch is lit

solid, then the default choice is enabled.

The above basic steps are used to edit and

select all UTILITY modes and parameters

on a Main Unit or Fader Pack.

Example of UTILITY Selection

Throughout the remainder of this Appen-

dix, UTILITY instructions are listed in ab-

breviated form. For example:

To access the Vegas Test Mode UTILITY

page:

■ In UTILITY mode, choose TEST > LED >

VEGAS.

The above instructs you to:

1 Press UTILITY.

2 Choose TEST from the UTILITY menu,

then

3 Choose LED from the TEST menu that

appears, then

4 Choose VEGAS from the LED menu.

For operations which take place purely

within the UTILITY menus, the short-form

instructions will appear. Wherever alter-

nate methods of invoking a UTILITY-level

parameter is available, its instructions are

included. Refer to the index of this guide to

locate specific settings.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 227 228

Comentários a estes Manuais

Sem comentários